Each time an airplane lands, there is depositing of about a pound or even a pound and a half of rubber on the runway. When there is an accumulation of the rubber it makes marks that are back and also starts to reduce the friction that is required for landing that is safe of an aircraft. The black marks on the surface are ugly and the administration of airports do not have to worry because there are existing companies that are dealing with the removal of the rubbers. However, the problem is not the way that the surface will look. When the companies start to remove the rubber from the runway, their aim is to restore the friction, and not just to remove the stains that are black.
In the case that the operation of removing rubber is removed in a way that is effective, then there is a high likelihood that the portion of the concrete surface will also be removed and this will lead to the loss of the life of a runway. In the case that it is done in a way that is proper the blasting of water needs to have a zero negative effect which is an indication that the life of the runway should not be lost. Because the level of friction is the aspect of the surface that is most essential and not even the appearance. A surface that is either damaged or compromised can cost an airport a lot of cash for doing the repairs of the runway.
There are companies in the market that have the needed technologies of removing rubber on the airway. The machines that are used are effective in quickly removing and completing all the forms of traffic markings that are durable without having negative impacts on the surface. The use of water jets and a system that is powerful of vacuum recovery is helpful in leaving the runway clean and almost dry. The debris that results is quickly dehydrated utilizing a process that is patented so that the debris can then be dumped in a state that is dried in a clump that is big that easily falls from the tank making cleanup of the job site in a way that is not only easy but also complete.
There are companies that have solutions that are leading because of the use of equipment of high-pressure water blasting for removing rubber I the runway. This is a method that is not only efficient but also innovative, productive, profitable, versatile and dependable for both the airports and the companies that are offering the services.
Every time the landing of an airplane takes place, there are amounts that are small of rubber that are left on the surface of the runway. The rubber then melts on the surface and can later go into the water drainage. After some time, the rubber causes friction which has impacts on the daily operations of a company especially when the airplanes are landing. However, there is no need for a person to be worried because there is already a solution at hand.